DIY BRACELET

We’ve been itching to make this DIY Bracelet since walking the aisles of the Home Depot store around the corner from our office. Some people see nuts and bolts and some people see jewelry beads. And we say tomato, tomahto! 
Our favorite aisle.

To make this bracelet, you just need a few supplies and the ability to braid. So first, gather your supplies:
Crown Bolt Machine Screw Nuts #8-32 in Brass, available at the Home Depot
Jute
Scotch tape
Chevron background, optional
Begin by cutting three equal pieces of jute and tying them together in a knot. Tape it down, and get braiding until you reach a third of the way down. Start adding the nuts on the right and left hand side of the braid before you loop each side over the center. Braid about 7-8 nuts on each side and then finish by braiding the end and tie the end in a knot. 

DIY BRACELET

We’ve been itching to make this DIY Bracelet since walking the aisles of the Home Depot store around the corner from our office. Some people see nuts and bolts and some people see jewelry beads. And we say tomato, tomahto! 

Our favorite aisle.

To make this bracelet, you just need a few supplies and the ability to braid. So first, gather your supplies:

Begin by cutting three equal pieces of jute and tying them together in a knot. Tape it down, and get braiding until you reach a third of the way down. Start adding the nuts on the right and left hand side of the braid before you loop each side over the center. Braid about 7-8 nuts on each side and then finish by braiding the end and tie the end in a knot.